*****************************************
	        			   	  README

				*****************************************
	
	    		           Chelsio T3 Family 10/1G RNIC driver 
                                           installer for Windows
		           

					Version : 1.5.13.1
					Date    : 10/09/2009



Overview
================================================================================================

Chelsio T3 Family 10/1G RNIC driver Installer is for Chelsio's T3 RNIC adapters.Access to the 
installer is through the downloadable file "chiwarp-1.5.13.1.zip", which is a compressed folder.
The installer allows you to install and load the driver.



================================================================================================
  CONTENTS
================================================================================================

-1.Requirements
-2.Supported Operating System
-3.Supported Cards
-4.How to Use
-5.Support Documentation
-6.Customer Support



1.Requirements
================================================================================================

- Chelsio - T3 10/1Gb adapter and system with below mentioned supported platforms.



2.Supported Operating System
================================================================================================

- Windows 2008 R2 (x64)
- Windows 2008 SP2 (x64)



3.Supported Cards
================================================================================================

- S302E-SR+
- S310E-CXA
- S310E-SR+
- S310E-SR
- S320E-CXA
- S320E-XFP
- S302E



4.How to Use
================================================================================================


Installation
------------------------------------------------

To install chiwarp-1.5.13.1 install shield package through command line you need to execute the 
following command.

chiwarp-1.5.13.1.exe /s /f1<path to install.iss file>

e.g. chiwarp-1.5.13.1.exe /s /f1C:\chiwarp-1.5.13.1\chiwarp-1.5.13.1\install.iss

**NOTE: No space between /f1 and C:\chiwarp-1.5.13.1\chiwarp-1.5.13.1\install.iss


Un-installation
------------------------------------------------

To uninstall chiwarp-1.5.13.1 install shield package through command line you need to execute 
the following command.
  
chiwarp-1.5.13.1.exe /s /f1<path to remove.iss file>
  
e.g. chiwarp-1.5.13.1.exe /s /f1C:\chiwarp-1.5.13.1\chiwarp-1.5.13.1\remove.iss

**NOTE: No space between /f1 and C:\chiwarp-1.5.13.1\chiwarp-1.5.13.1\remove.iss
- This Driver is WHQL certified.
- Please restart your machine after unstalling/installing iWARP drivers.


5.Support Documentation
================================================================================================

The documentation for this release can be found in the <system_drive>\Chelsio\doc\ directory 
after installation
It contains:

- NdWsdInstallGuide.pdf



6.Customer Support
================================================================================================

Please contact Chelsio support at support@chelsio.com for any issues regarding the product.








************************************************************************************************
Copyright (C) 2010 Chelsio Communications.
All Rights Reserved


The information in this document is furnished for informational use only, is subject to change 
without notice, and should not be construed as a commitment by Chelsio Communications. Chelsio 
Communications assumes no responsibility or liability for any errors or inaccuracies that may 
appear in this document or any software that may be provided in association with this document. 
Except as permitted by such license, no part of this document may be reproduced, stored in a 
retrieval system,or transmitted in any form or by any means without the express written consent 
of Chelsio Communications.